Servo Applications: The Ability to Heat Material In-Die

Like a digital camera, a mac book, where you can heat the material, typically only able to be done in a hydraulic press.  You see the curve a to b you load on the material face down.  B to c you’re holding, without pressure, so to heat the material of magnesium to specific temperature to then down and then go back.  D and E is where the metal is being pushed to create the sides of the chassis.  The dies is actually heating.  This could be magnesium, titanium, other alloys that require heating or warm forming.  8mm and 0 mm is height above bottom dead center.

No comments:

Post a Comment